Single Head Fixed Output Metering Pump - 45MP2 Classic Series From Stenner

• 25 psi (1.7 bar)

• max 10 gpd (38 lpd)

How It Works

Stenner’s fixed output metering pump is built with two detachable components: the motor and pump head. Outputs are dependent upon the rpm of the motor gears and the size of the peristaltic pump tube. The fixed rate pump has no output adjustment. All Stenner metering pumps have a 3-point roller design in the pump head, which acts as a check valve to prevent back flow, siphoning, overdosing and loss of prime.

The motor’s output shaft rotates at a fixed rpm which drives the roller assembly within the pump head. The chemical solution in the pump tube is captured between the rollers as they rotate and compress the tube. As the rollers advance, the squeezed tube section regains its original form and generates a vacuum, creating the self-priming feature that delivers a constant flow unaffected by the outlet pressure.

Advantages

• Self-priming up to 25 feet and does not lose prime

• Can pump off-gassing solutions

• Solutions contained in tube, not exposed to pump components or air

• Subassemblies fit together without tools; easy service or conversion to another model

• Pump head universal to all Stenner pumps

• Can run dry without damage

• Will not clog from dirt or debris

• Reproducible outputs within 2%

• Adjustable feed rate control from 5%-100% in 2.5% increments

• Pump tubes accept a variety of chemicals

45MP2 Classic Series

A rotating assembly of rollers compresses a flexible tube within a housing to create a vacuum to lift a chemical solution. The self-priming peristaltic pump is also referred to a hose, tube or dosing pump.

Classic Series Pump
        - Installation
Classic Series Pump
        - FAQ's
Classic Series Pump
        - 45 Spec Sheet
Classic Series Pump
        - 85 Spec Sheet

Materials of Construction
All Housings: Lexan® polycarbonate plastic
Pump tube: Santoprene® FDA approved
Pump tube: Tygothane® FDA approved
Suction/discharge tubing & ferrules (1/4" & 6 mm): LDPE polyethylene,
NSF/FDA approved
Tube fittings, connecting nuts, check valve fitting,
weighted strainer: Type 1 Rigid PVC-NSF listed
All fasteners: Stainless Steel
Lexan® is a registered trademark of General Electric.
Santoprene® is a registered trademark of Advanced Elastomer system
Tygothane® is a registered trademark of Saint-Gobain Performance Plastics
Pellathane® is a registered trademark of The Dow Company

Agency listings
Santoprene®: UL, CSA , CE, NSF-61
Tygothane®: UL, CSA, CE

Accessories shipped with each pump
3 connecting nuts 1/4" or 3/8"
3 ferrules 1/4" & 6 mm OR 2 ferrules 3/8"
1 injection check valve
1 weighted strainer
1 20' roll of suction/discharge tubing 1/4" or 3/8" white or UV black
OR 6 mm (Europe) white
1 spare pump tube
1 mounting bracket
1 installation manual